Descripteur
Termes IGN > 1- Outils - instruments et méthodes > document > document d'urbanisme > autorisation d'urbanisme > permis de construire > plan de masse
plan de masseVoir aussi |
Documents disponibles dans cette catégorie (1)
![](./images/expand_all.gif)
![](./images/collapse_all.gif)
![Tris disponibles](./images/orderby_az.gif)
Etendre la recherche sur niveau(x) vers le bas
Reducing multipath effect of low-cost GNSS receivers for monitoring by considering temporal correlations / Li Zhang in Journal of applied geodesy, vol 14 n° 2 (April 2020)
![]()
[article]
Titre : Reducing multipath effect of low-cost GNSS receivers for monitoring by considering temporal correlations Type de document : Article/Communication Auteurs : Li Zhang, Auteur ; Volker Schwieger, Auteur Année de publication : 2020 Article en page(s) : pp 167 – 175 Note générale : bibliographie Langues : Anglais (eng) Descripteur : [Vedettes matières IGN] Géodésie spatiale
[Termes IGN] atténuation du signal
[Termes IGN] corrélation temporelle
[Termes IGN] coût
[Termes IGN] itération
[Termes IGN] ligne de base
[Termes IGN] oscillation
[Termes IGN] phase
[Termes IGN] plan de masse
[Termes IGN] qualité des données
[Termes IGN] récepteur GNSS
[Termes IGN] récepteur monofréquence
[Termes IGN] réflecteur
[Termes IGN] source d'erreur
[Termes IGN] trajet multipleRésumé : (auteur) The investigations on low-cost single frequency GNSS receivers at the Institute of Engineering Geodesy (IIGS) show that u-blox GNSS receivers combined with low-cost antennas and self-constructed L1-optimized choke rings can reach an accuracy which almost meets the requirements of geodetic applications (see Zhang and Schwieger [25]). However, the quality (accuracy and reliability) of low-cost GNSS receiver data should still be improved, particularly in environments with obstructions. The multipath effects are a major error source for the short baselines. The ground plate or the choke ring ground plane can reduce the multipath signals from the horizontal reflector (e. g. ground). However, the shieldings cannot reduce the multipath signals from the vertical reflectors (e. g. walls). Because multipath effects are spatially and temporally correlated, an algorithm is developed for reducing the multipath effect by considering the spatial correlations of the adjoined stations (see Zhang and Schwieger [24]). In this paper, an algorithm based on the temporal correlations will be introduced. The developed algorithm is based on the periodic behavior of the estimated coordinates and not on carrier phase raw data, which is easy to use. Because, for the users, coordinates are more accessible than the raw data. The multipath effect can cause periodic oscillations but the periods change over time. Besides this, the multipath effect’s influence on the coordinates is a mixture of different multipath signals from different satellites and different reflectors. These two properties will be used to reduce the multipath effect. The algorithm runs in two steps and iteratively. Test measurements were carried out in a multipath intensive environment; the accuracies of the measurements are improved by about 50 % and the results can be delivered in near-real-time (in ca. 30 minutes), therefore the algorithm is suitable for structural health monitoring applications. Numéro de notice : A2020-217 Affiliation des auteurs : non IGN Thématique : POSITIONNEMENT Nature : Article nature-HAL : ArtAvecCL-RevueIntern DOI : 10.1515/jag-2019-0059 Date de publication en ligne : 27/03/2020 En ligne : https://doi.org/10.1515/jag-2019-0059 Format de la ressource électronique : url article Permalink : https://documentation.ensg.eu/index.php?lvl=notice_display&id=94910
in Journal of applied geodesy > vol 14 n° 2 (April 2020) . - pp 167 – 175[article]